Measurement-computing Analyzer488 Manual de usuario descargar pdf (Pagina 209)

Section 5 Analyst488 Software

5.21

5.10.10 Goto Reference

This command moves the cursor in the active window to the reference

location (relative location 0). The reference location is set by the Set

Reference command.

5.11 Handshake Menu

The handshake menu lets you change the handshaking speed of the Analyzer488.

It also lets you change the Talk and Listen states.

5.11.1 Listen

This command configures the Analyzer488 handshake circuitry to

perform an acceptor handshake and accept data from the bus. The

handshake speed may be set to Fast, Slow, Step, or None.

This command may also be selected without pulling down the

Handshake menu by pressing

5.11.2 Talk

This command configures the Analyzer488 handshake circuitry to

perform a source handshake and place data on the bus. The handshake

speed may be set to Fast, Slow, Step, or None.

This command may also be selected without pulling down the

Handshake menu by pressing

5.11.3 Fast

This command allows the Analyzer488 to participate in bus events

without limiting the event speed. The Fast handshake speed may not be

useful in viewing bus events because the display rate cannot keep up with a

fast bus event rate.

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 280 281

Sin comentarios

Measurement-computing Analyzer488 Manual de usuario Pagina 209