Measurement-computing Analyzer488 Manual de usuario descargar pdf (Pagina 195)

Section 5 Analyst488 Software

5.7

At the

CMD>

prompt, you may type any of the Serial Controller

commands listed below. If a particular command returns a response, the

response will be printed on the screen.

The following commands may be issued when using the Command

Line Controller window:

ADDRESS LOCAL LOCKOUT PPOLLU TRIGGER

ABORT OUTPUT REMOTE TERM

CLEAR PPOLL RESUME

ENTER PPOLLC SEND

LOCAL PPOLLD SPOLL

This command may also be selected without pulling down the File

menu by pressing

<F5>

For further information on the above commands and syntax, refer to

the Serial Controller section (Section 4) of this manual.

5.7.6 Mark Block

This command sets the present cursor position as the beginning of a

block of data in a window. The cursor keys may then be used to select the

size of the block to be marked. The marked block is displayed in reverse

video for easy identification.

This command is used to select a portion of the data in a window for

writing, printing, searching, or transferring. This command is also used to

remove the current block marker from the active window.

This command may also be selected without pulling down the File

menu by pressing

<F6>

5.7.7 Mark All

This command is used to mark an entire block of data in a window

for writing, printing, searching or transferring.

This command may also be selected without pulling down the File

menu by pressing

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 280 281

Sin comentarios

Measurement-computing Analyzer488 Manual de usuario Pagina 195