Measurement-computing Analyzer488 Manual de usuario descargar pdf (Pagina 133)

Section 4 Serial Controller

4.39

The

command allows the user to change the

command character

to any printable ASCII character. The new

command character must immediately

follow the semi-colon without any intervening spaces. If the double

character

command is issued, the

character will default back to '

The

and

command can be disabled by not including a character

following the semicolon. It can be re-enabled again by issuing the

command with a

valid character.

If you anticipate that the

data

part of an

OUTPUT

SEND

command may

contain the presently programmed

character, it should be disabled.

TYPE System command

SYNTAX

ID;

[

ascii

]

ascii

is any printable ASCII character immediately following the

semi-colon (

;

)

RESPONSE None

MODE Any

BUS STATES None

QUERY None

RESPONSE

EXAMPLES PRINT #1,"ID;#"

change the

character to

PRINT #1,"ID;"

disable the

commands

PRINT #1,"ID;@"

re-enable the

character to

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 280 281

Comentarios a estos manuales

Sin comentarios

Measurement-computing Analyzer488 Manual de usuario Pagina 133

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Measurement-computing Analyzer488