Measurement-computing Personal488 rev.1.0 Manual de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 40
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
Windows 2000 & Windows XP
3-16 Installation 889496 Personal488 for Windows 95/98/Me/NT/2000/XP
Hardware Installation for Windows 2000 & Windows XP Users
Note: Although Windows 2000 is mentioned in the following text, users of Windows XP should be able to
easily follow these same instructions, with minor, but obvious exceptions. This is due to the fact that
the procedure for Windows XP is very close to that of Windows 2000.
Plug-and-Play Devices
Personal488/PCI
Personal488/ATpnp
Personal488/Card
1. If you have not already done so, shutdown Windows 2000 after the IEEE 488 software has been
successfully installed.
2. Remove power from the PC.
3. Physically install your interface. As a quick reference,
Personal488/PCI installs into a 32-bit PCI expansion slot,
Personal488/ATpnp installs into a 16-bit ISA expansion slot, and
Personal488/Card installs into a PC card slot.
4. Return power to the PC. After the computer powers up, Windows 2000 will detect your new
hardware.
At this point refer to the full-version PDF. See page v for location.
“Non plug-and-play” Devices
Personal488/AT (AT488)
Personal488 (GP488B)
Personal488/MM
1. If you have not already done so, shutdown Windows 2000 after the IEEE 488 software has been
successfully installed.
2. Remove power from the PC.
3. Physically configure the device’s jumpers and switches to match the resource settings Windows 2000
reported during the driver installation.
Non plug-and-play board users: physically configure your board’s jumpers and switches
to match the resource settings Windows reported. If these settings conflict with other
hardware change the jumpers, switches, and Windows Resource settings to available
resources.
Reference Note:
Refer to Chapter 4, Hardware Configuration Reference for further information concerning
jumpers and switches.
4. Return power to the PC.
At this point refer to the full-version PDF. See page v for location.
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Comentarios a estos manuales

Sin comentarios