Measurement-computing Personal488 rev.1.0 Manual de usuario descargar pdf (Pagina 20)

Windows Me

3-10 Installation 889496 Personal488 for Windows 95/98/Me/NT/2000/XP

Hardware Installation for Windows Me Users

Plug-and-Play Devices

Personal488/PCI

Personal488/ATpnp

Personal488/Card

1. If you have not already done so, shutdown Windows Me after the IEEE 488 software has been

successfully installed.

2. Remove power from the PC.

3. Physically install your interface. As a quick reference,

Personal488/PCI installs into a 32-bit PCI expansion slot,

Personal488/ATpnp installs into a 16-bit ISA expansion slot, and

Personal488/Card installs into a PC card slot.

4. Return power to the PC. After the computer powers up, Windows Me will detect your new hardware.

At this point refer to the full-version PDF. See page v for location.

“Non plug-and-play” Devices

Personal488/AT (AT488)

Personal488 (GP488B)

Personal488/MM

1. If you have not already done so, shutdown Windows Me after the IEEE 488 software has been

successfully installed.

2. Remove power from the PC.

3. Physically configure the device’s jumpers and switches to match the resource settings Windows Me

reported during the driver installation.

Non plug-and-play board users: physically configure your board’s jumpers and switches

to match the resource settings Windows reported. If these settings conflict with other

hardware change the jumpers, switches, and Windows Resource settings to available

resources.

Reference Note:

Refer to Chapter 4, Hardware Configuration Reference for further information concerning

jumpers and switches.

4. Return power to the PC.

At this point refer to the full-version PDF. See page v for location.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Sin comentarios

Measurement-computing Personal488 rev.1.0 Manual de usuario Pagina 20