Measurement-computing Personal488 rev.1.0 Manual de usuario descargar pdf (Pagina 18)

3-8 Installation 889496 Personal488 for Windows 95/98/Me/NT/2000/XP

Windows Me Users

Software Installation

• For best results, install the interface after the software installation.

• If installing a second non plug-and-play interface, skip step 1.

• If installing a second plug-and-play interface, go to “Hardware Installation.”

Step 1

Insert the IEEE488 Software CD. The CD has an auto-run program that will automatically start the

setup program when the CD is inserted into the CD ROM driver. If auto-run is disabled, use Explorer

to launch the Setup.exe found in the root directory of the CD. Follow the screen prompts to install the

software. Then if non plug-and-play hardware is being installed, proceed to step 2; otherwise proceed

to Hardware Installation for Windows Me Users on page 3-10.

Step 2

Use the “Add New Hardware” program found in the Control Panel to notify Windows Me that you are

installing new hardware. Refer to the following steps that demonstrate the typical Windows panels

encountered during the “Add New Hardware” program execution:

Start

⇒

Settings

⇒

Control Panel

⇒

Add New Hardware

Add New Hardware Procedure (non plug-and-play users only):

It is only necessary for users of “non plug-and-play” boards to follow the Add New

Hardware Procedure. If your device is a “plug-and-play device,” skip this procedure.

The “Add New Hardware Wizard” displays an introductory message and prompts you to click Next.

1. Click Next.

2. Select ‘No, the device isn’t in the

list’ and click Next.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Sin comentarios

Measurement-computing Personal488 rev.1.0 Manual de usuario Pagina 18