
Getting Started, pg. 22
11-01-01
ZonicBook
If the DSP-Card does not respond in Windows NT, try the following:
1.
From the desktop, open the Control Panel. This is done by navigating as follows:
Start
⇒
Settings
⇒
Control Panel
⇒
System
⇒
Device Manager
⇒
CACDSP
Note: “CACDSP” represents the DSP-Card device
2.
Double-click the “CACDSP” (DSP-Card) device.
3.
Click the <Start> button. This starts the DSP-Card without the need to reboot the computer.
4.
To enable or disable the DSP-Card, click the <Startup> button, then click the <Enable> or the
<Disable> button as applicable.
5.
Click the <HW Profiles> button.
6.
If the Startup method is not set to “Automatic,” set the DSP-Card for “Automatic” startup.
Windows NT Users
Comentarios a estos manuales