Measurement-computing DBK Part 2 Manual de usuario descargar pdf (Pagina 219)

An Example of Customer-Installed Capacitors and Filters for RC Networks on a DBK202

Prior to installing RC components, review the previous WARNING and CAUTION statements; then read

over the following information regarding resistors and capacitors.

• Do not use RC filters in conjunction with additional DBK expansion accessories.

• Prior to installing a resistor to the filter network you must drill a 1/16” hole through

the center pinhole [beneath the board’s silkscreen resistor symbol] as indicated in the

above figure. Failure to do so will short-circuit the resistor.

• Do not drill holes on the board for channels, unless those channels are to receive a

filter network (see preceding statement).

• Resistors should be ¼ watt, film-type with up to 5% tolerance. Do not use wire-

wound resistor types.

• A resistor value of 510 Ω is recommended. Do not exceed 510 Ω.

• Capacitors used are to be of the film dielectric type (e.g., polycarbonate or

NPO ceramic), above 0.001 µF.

• RECOMMENDED: For reduction of both Common Mode Noise and Differential

Mode Noise, use one capacitor between Channel High and AGND; and use a second

capacitor between Channel Low and AGND.

• For reduction of Differential Noise [when no reduction of Common Mode Noise is

needed] position a capacitor across the respective Channel High and Channel Low.

• When in Differential Mode, using capacitors between Channel High, Channel Low,

and AGND may cause a slight degradation of wideband Common Mode rejection.

• When making a RC filter network, always install a wire jumper between the relevant

FILT CAP LO and AGND. FILT CAP LO terminals are located on TB9 and TB10.

DBK Option Cards and Modules 938994 DBK202, DBK203, and DBK204 Series, pg. 13

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 305 306

Sin comentarios

Measurement-computing DBK Part 2 Manual de usuario Pagina 219