Measurement-computing CIO-DAS800 Manual de usuario descargar pdf (Pagina 8)

3 CONNECTOR DIAGRAM

The CIO-DAS800 analog connector is a 37-pin, D-type connector accessible from the rear of the PC

through the expansion backplate (Figure 3-1). The connector accepts female 37-pin D-type connectors,

such as those on the C37FF-2, a 2-foot cable with connectors.

If frequent changes to signal connections or signal conditioning is required, please refer to the

information on the CIO-TERMINAL and CIO-MINI37 screw terminal boards, CIO-EXP32, 32 channel

analog MUX/AMP. Isolation amplifiers can be mounted using the ISO-RACK08 and 5B isolation

modules.

Figure 3-1. Analog Connector

WARNING - PLEASE READ

Measure the voltage between the ground signal at the signal source and the PC. Use a

high input impedance voltmeter. If there more the 10 volts, do not connect the

CIO-DAS800 to this signal source because you will not be able to make a reading. If the

difference is more than 30 volts, DO NOT connect this signal to the CIO-DAS800

because IT WILL DAMAGE the board and possibly the computer.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

Measurement-computing CIO-DAS800 Manual de usuario Pagina 8