Measurement-computing CIO-DAS6402/12 Manual de usuario descargar pdf (Pagina 6)

3 HARDWARE INSTALLATION

3.1 BASE ADDRESS

Unless there is already a board in your system using address 300h (768 Decimal), leave the switches as they are set at the factory.

In Figure 3-1, the CIO-DAS6402 is set at base address 300h. See Figures 3-6 and 3-7 for the locations of the switches

Figure 3-1. Base Address Switches

3.2 D/A OUTPUT RANGE SWITCH (CIO-DAS6402/16 ONLY)

The analog output ranges of the CIO-DAS6402/12 are set via software. The analog output ranges of the CIO-DAS6402/16 are set

by dip switches on the board (Figure 3-7). Figure 3-2 shows the the allowable switch settings and Table 3-1 gives the range/switch

settings.

Figure 3-4. D/A Output Range Switches

HEX

200

100

BASE ADDRESS SWITCH

- Address 300H shown here.

CIO-DAS6402/16 Analog Output

Configuration Switch

(shown as +/- 10 Volt full-scale)

1 2 3 4 5

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Sin comentarios

Measurement-computing CIO-DAS6402/12 Manual de usuario Pagina 6