Measurement-computing 200 Series DaqBook Manual de usuario Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 54
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
3-18 DaqBook Hardware
01-23-02
DaqBook Users Manual
Using T-Cables
&$87,21
Turn power OFF to the Daq devices and externally connected equipment while
connecting cables and setting configuration jumpers and switches or before opening
the lid. Electrical shock or damage to equipment can result even under low-voltage
conditions.
T-Cables are available in different lengths and can be used for linking two or more compatible devices
together via the devices 37-pin digital I/O connectors.
The bottom-end of the T-Cable is a dual-connector, consisting of both a female connector, and a 37-pin
(male) connector. As seen in the following illustration, the T-Cables 37-pin (male) connector can be used
for Daisy-Chain applications.
Each T-Cable comes with three sets of screws. These are designated (in the diagram) as: short, medium, and
long. Use the short screws to secure the single, female-end of the cable to the device; and use the medium
length screws to secure a cables dual-end connector. Use the long screws for daisy-chain applications
(when you are connecting one T-Cable to another T-Cable).
Tighten screws snug only; do not over-tighten!
Daisy-Chain Example, Using Two T-Cables
Daisy-Chain Example, Using two T-Cables
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 53 54

Comentarios a estos manuales

Sin comentarios