Measurement-computing 200 Series DaqBook Manual de usuario Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 54
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
3-16 DaqBook Hardware
01-23-02
DaqBook Users Manual
12 Install termination panels
Mount the termination panels to the card drawer with two screws for each panel.
13 Install card drawer
The card drawer slides into the bottom track of the chassis.
A.
Hold the card drawer by its handle and tilt it up slightly. Place it on the bottom track of the chassis.
B.
Carefully slide the card drawer into the chassis. When it engages the bottom track, level the card drawer and
continue inserting it until it engages with the P1 interconnect board.
C.
Tighten the three captive thumbscrews holding the termination panels to the chassis.
D.
Install the two screws holding the card drawer to the chassis.
14 Connect external signals
Connect signal inputs from sensors to termination panels.
15 Install top cover
Slide on the top cover and install the two top cover screws.
16 Turn on system power and check operation
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

Comentarios a estos manuales

Sin comentarios