Measurement-computing ZonicBook 618E rev.3.4 Manual de usuario descargar pdf (Pagina 38)

5-4 System Setup and Power Options 947091 ZonicBook/618E User’s Manual

STEP 1 – Install the Software

Install the software prior to connecting the ZonicBook/618E to the Ethernet. If you have not already installed the software,

do so at this time. Refer to the section entitled Software Installation, page 5-2.

STEP 2 – Determine the type of Network Connection

To properly connect and configure a ZonicBook/618E, you must determine the type of network that the

device will become part of. This is because the type of network used has a direct bearing on the IP address

of the device.

Briefly, the four network types are as follows:

Dedicated Network - with a direct cable connection from the PC to the device

Dedicated Network - making use of a network hub or switch

LAN with a DHCP server

(Local Area Network with a Dynamic Host Configuration Protocol)

LAN without a DHCP server

(Local Area Network with no Dynamic Host Configuration Protocol)

Brief descriptions and illustrations follow.

Dedicated Network - with a direct cable connection from the PC to the device

In this scenario a ZonicBook/618E is connected directly to an Ethernet jack on a host computer.

Dedicated Network using a Direct Cable Connection

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 121 122

Sin comentarios

Measurement-computing ZonicBook 618E rev.3.4 Manual de usuario Pagina 38