
Chapter 3
Functional Details
The USB-PDISO8/40 provides SPDT relay control and isolated inputs in a plug-and-play package. All I/O
connections are made to a 40-pin connector (refer to Table 2-2 on page 2-4 for the signal pin out).
Internal components
The USB-PDISO8/40 has the following internal components, as shown in . Figure 3-1
Figure 3-1. USB-PDISO8/40 components
Two (2) USB connectors
Two (2) external power connectors
USB LED
PWR LED
40-pin I/O connector
PWR LED
USB LED
USB I
POWER
OUT
POWER IN
USB
OUT
40-pin connector
USB OUT connector
The USB OUT connector is a downstream hub output port intended for use with other Measurement Computing
USB products only. The USB hub is self-powered, and can provide 100 mA maximum current at 5 V. The USB
out connector is labeled
USB OUT on the enclosure and on the board.
For information on daisy chaining to other compatible Measurement Computing USB products, refer to "Daisy
chaining additional modules to the USB-PDISO8/40
" on page 3-3.
USB IN connector
Connect the USB IN connector to the USB port on your computer (or USB hub connected to your computer).
The USB in connector is labeled
USB IN on the enclosure and on the board.
3-1
Comentarios a estos manuales