
Appendix A – Specifications, ISA-Type DaqBoards
02-14-02
A-3
High-Speed Digital Inputs
for DaqBoard/200A
16 input lines
Connector:
DB37 male, P3 (on-board 40-pin DIN is externally accessible
via DB37 with optional CA-60)
Maximum Sampling Rate:
100 kHz
Input Low Voltage:
0.8V max
Input High Voltage:
2V min
Input Low Current:
10 nA
Input High Current:
-10 µA
Counter/Timer
for DaqBoard/200A
5 counter/timer channels
Connector:
DB37 male, P3 (on-board 40-pin DIN is externally accessible
via DB37 with optional CA-60)
Frequency/Pulse Counting Mode:
Up or down, binary or BCD
Maximum Pulse Count:
80-bit binary; (5 channels cascaded)
Maximum Input Rate:
7 MHz
Minimum High Pulse Width:
70 ns
Minimum Low Pulse Width:
70 ns
On-board Time Base:
1 MHz
Input Low Voltage:
0.8V max
Input High Voltage:
2.0V min
Input Low Current:
-0.1 mA
Input High Current:
20 µA max
Frequency/Pulse Generating Mode
Maximum Output Frequency:
1 MHz
Duty Cycle:
Variable between limits of approximately 0.0015% and 99.99%
Output High Voltage:
2.4V min @ 15 mA
Output Low Voltage:
0.5V max @ 24 mA
Cable Information Part No.
Adapter cable for the DaqBoard/200A P2 or P3 port CA-60
Ribbon cable (6 ft) with a female DB37 connector on one end, unterminated
on the other. This cable provides convenient wiring to DaqBoard P1, P2, &
P3 ports.
Note
: For a cable distance of more than 6 feet, attachment to a
DaqBoard/200A P2 or P3 requires the use of an optional
CA-60 cable.
CA-113
Expansion cable from ISA DaqBoard to DBK expansion products CA-131-1T
Shielded expansion cable from DaqBoard to DBK41; 7 in. CA-143-7
Shielded expansion cable from DaqBoard to DBK41; 18 in. CA-143-18
Note
: Specifications are subject to change without notice.
Comentarios a estos manuales