Measurement-computing ADAC/5500 Series Installation Manual de usuario

ADAC/5500 Series Installation Guide PCI Data Acquisition Boards the smart approach to instrumentation ™ IOte

Pinouts This section contains pinouts for the various ADAC/5500 Series Boards and the terminal boards that can be used with them, i.e., ADAC-TB-8, ADA

J1 Pin Assignments for ADAC/5501MF, ADAC/5502MF, ADAC/5503HR, and ADAC/5504HR Standard 68-Pin SCSCI Type III, Socket (Female) Connector with Orb Pin

P3 and P5 Pin Assignments The ADAC/5501MF, ADAC/5502MF, ADAC/5503HR and ADAC/5504HR include two auxiliary 40-pin headers. These are located on the b

Signal Definitions for P3, P5, and GB17’s DB37 Connector The following descriptions apply to each of the signals that are available at the 40-pin aux

ADAC-TB-8 Screw-Terminal Board Connections The ADAC-TB-8 provides screw-terminal access to all of a ADAC/5500MF board’s analog and digital I/O signal

ADAC-TB-16 Screw-Terminal Board One ADAC-TB-16 provides screw-terminal access to all analog and digital I/O signals from any one of the following boar

ADAC-DC-37 Screw-Terminal Board for Auxiliary Digital I/O The ADAC-DC-37 provides access to 16 of the 32 available auxiliary digital I/O channels fro

Warranty Information Your IOtech warranty is as stated on the product warranty card. You may contact IOtech by phone, fax machine, or e-mail in rega

ADAC/5500 Series, Installation 1107-0940, rev 2.0 908096 ADAC/5500 Series Installation Guide 3 Contents Intr

ADAC/5500 Series Boards Feature /5500MF /5501MF /5501MF-V /5502MF /5502MF-V /5503HR /5503HR-V /5504HR /5504HR-V Analog Inputs 8 Single-Ended 16 Si

Step 1 – Install Software IMPORTANT: Software must be installed before installing hardware. 1. Remove previous version ADAC drivers, if present.

6 ADAC/5500 Series Installation Guide 908096 1107-0940, rev 2.0

Step 2 – Install Boards in available PCI Bus-slots IMPORTANT: Software must be installed before installing hardware. WARNING Turn OFF power

7. Align the groove in the ADAC/5500 Series board’s PCI edge-connector with the ridge of the desired PCI slot. See preceding right-hand figure. 8.

Step 3 – Configure Boards WARNING Always turn the computer power OFF and unplug it before connecting or disconnecting a screw terminal panel or a