Measurement-computing CIO-DAC16-I Manual de usuario Pagina 8

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 7
3.4 Cabling to the CIO-DAC##-I
The CIO-DAC##-I connector is accessible through the PC/AT expansion bracket.
The connector is a standard 37-pin D-type male connector. A mating female
connector, such as the C37FF-2, is available from Measurement Computing.
Several cabling and screw termination options are available from Measurement
Computing.
A screw terminal board that accepts spade lugs with
on-board area for prototyping circuitry.
CIO-SPADE 50
4 X 16-in. screw terminal board with on-board
prototyping area.
CIO-TERMINAL
37-position, 4 X 4-in. screw terminal boardCIO-MINI37
5 foot shielded round cable with molded ends
housing 37-pin female connectors. Also in 10 ft.
C37FFS-5
2 foot (and longer) ribbon cable with 37 pin D
female connectors
C37FF-2
D connector, D shell and termination pins to
construct your own cable
DFCON-37
3.5 Testing the Installation
You can test the installation of the CIO-DAC##-I using InstaCal. Select the Test
option to vary the output voltages and monitor them with a Volt Meter.
4
Vista de pagina 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios